User Guide

www.BISSELL.com
15
Trbleshting
WARNING
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Problem Possible causes Remedies
Heater ready
light does not
illuminate
The heater switch is not turned
ON ( I ).
Turn ON ( I ) the heater switch.
The machine power switch is not
to turned ON ( I ).
Both switches must be ON ( I ) to
activate the heater ready light.
Reduced
spray or
no spray
Bladder may be empty. Refill bladder with hot tap water.
Heater tank may be empty. Fill with BISSELL Deep Cleaning
formula for cleaning. Fill with water
if rinsing.
The filter may be clogged. Clean out flow indicator filter, page 13.
Tanks may not be seated properly. Turn power OFF (O); remove &
reseat tanks.
Pump may have lost prime. Turn power OFF (O); after 1 minute
turn ON and press trigger.
The Pump belt may be broken. Turn on the machine and check to
see that the DirtLifter PowerBrush
turns. If it does not, refer to #1 below.
DirtLifter®
PowerBrush
does not turn
The brush belt or pump belt is
off or broken.
Turn the machine OFF (O) and unplug
from the outlet. To check if the brush
belt or pump belt has broken, you will
need a flat head screwdriver. Insert the
blade end into the lower slot of the
belt access door to release the lower
snap. If necessary, insert the blade
end into the upper slot to release
the upper snap. Examine the belt for
breakage. If broken, please refer to
Replacement Parts on page 17 before
calling Consumer Care. Complete
installation instructions will accom-
pany the replacement belt.
Lift Here