User Guide

www.BISSELL.com
6
The only thing you will need to assemble your
deep cleaner is a Phillips head
screwdriver.
1. Slide upper handle onto lower handle.
2. Feed bundled power cord through tool
caddy from caddy’s flat side.
3. Align tool caddy holes with upper handle
holes.
4. Place hex nut into back of tool caddy and
hold in place. Insert bolt from front to back
turning into the hex nut until snug. Do not over
tighten. Repeat for the second bolt and hex nut.
5. Insert 2 screws into lower 2 holes (located just
above the lower hose rack). Turn until tightened.
6. Attach tool(s) to end of hose or front of
upper handle.
7. Wrap power cord and flex hose as shown in
figure 7.
Asmbly
WARNING
Do not plug in your deep cleaner until
you are familiar with all instructions and
operating procedures.
1. 2.
4.
5.
7.
3.