User`s guide

www.bissell.com

Troubleshooting

Cleaner not picking up solution

Possible Causes Remedies

1. ReadyTools dial may be at wrong setting. 1. Set ReadyTools dial to either floor

cleaning or tools setting.

2. 2-in-1 water tank may not be 2. Pick up both the 2-in-1 water tank and

seated properly. formula tank and reseat them so they fit

snugly on the unit.

3. 2-in-1 water tank may not be 3. Check to make sure the "lip" of the

assembled properly. nozzle is securely hooked into the

groove on bottom of Tank (see page 10).

4. Formula or 2-in-1 water tank is empty. 4. Check fluid levels in heavy duty bladder

and bladder and formula tank.

5. 2-in-1 water tank has picked 5. Empty 2-in-1 water tank. Refill heavy

up maximum dirty water and red duty bladder with clean hand hot tap

float door has closed. water and replace.

6. Red float "door" in the tank may 6. Turn the power switch OFF ( O ), allowing

have closed as a result of bumping red float door to release into the open the

an object or moving machine back and position. Turn unit back ON ( I ) to continue

too quickly. cleaning. Be sure your forward and

backward strokes are done at a

slower pace.

Other maintenance or service not included in the manual should be performed by an

authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store.

ug120-4042_9500E.indd 24ug120-4042_9500E.indd 24 5/7/08 3:37:49 PM5/7/08 3:37:49 PM