Spot Lifter ® POWERBRUSH HAND HELD DEEP CLEANER USER’S GUIDE 1716 SERIES 3 Safety Instructions 4 Product View 5 Product Features 6-7 Operations 8-9 Maintenance and care 9-10 9-10 Troubleshooting 10 Consumer Services 12 11 Replacement Parts 12 Warranty
Thank you for buying a BISSELL Spot Lifter® Powerbrush We’re glad you purchased a BISSELL Spot Lifter PowerBrush. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Spot Lifter PowerBrush is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate assistance.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: Read all instructions before using your Spot Lifter® Powerbrush WARNING - To reduce the risk of fire, electric shock, or injury: ■ Do not use for any purpose other than described in this User’s Guide. ■ Use only BISSELL cleaning products intended for ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ use in this appliance. Use only manufacturer’s recommended attachments.
Product view Solution Tank Power Switch Spray Trigger Solution Tank Release Tabs Power Cord Removable Brush Cartridge with Dual PowerBrushes Collection Tank Belt Cover Door Spray Nozzle Circuit Interrupting Device (C.I.D.) Caution: Only use one of BISSELL's advanced formulas for portable deep cleaning machines in your cleaner. Use of cleaning formulas which contain lemon or pine oil may damage this appliance and void warranty. Do not use chemical spot cleaners or solvent-based soil removers.
Product features Solution tank. Holds 2X Little Green® formula and water. Collection tank. Collects dirty water and solution. You will need to remove the solution tank before you can remove the collection tank. Spray trigger. Dispenses water and solution. Solution tank release tabs. Gently press in to remove the clean/solution Tank. Circuit Interrupting Device (C.I.D.). Because you will be using this product in wet environments, such as bathrooms, we have equipped this unit with this added safety feature.
Operations Filling the solution tank 1. Remove the solution tank by gently pressing the quick release tabs on the solution tank and sliding the tank off of the unit. 2. Open the tank by unscrewing and removing the cap. Add water and formula* to the indicated fill lines on the solution tank. 1. *NOTE: Your Spot Lifter PowerBrush includes an 8 oz. trial size formula. 3. 2. Replace the cap before placing the tank back on the unit.
Operations Cleaning (continued) 5. Check the collection tank and empty the tank if it is full (See To empty the collection tank, page 8). 6. If the Spot Lifter PowerBrush stops spraying, turn off the unit and check the cleaning solution level in the solution tank. Refill if needed. Never run the unit without water or cleaning solution. Spot cleaning upholstery 1. Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your Spot Lifter PowerBrush.
Maintenance and care Machine care 1. Turn the power switch to the “OFF” position. ( O ) 2. Unplug the unit. 3. Carry the Spot Lifter PowerBrush to the sink or drain. 1. To empty the collection tank 1. Begin by removing the solution tank. Gently press the quick release tabs on the solution tank and slide the tank off of the unit. 2. Grasp the collection tank and pull to remove. 3. While at the sink, remove the tank cap by unscrewing and lifting out. 4. Empty the tank.
Maintenance and care (continued) Tip: Storage If you do not have the Brush Cartridge in all the way, the Dual PowerBrushes will not rotate. Firmly push the cartridge in place, while listening for the “snap” to assure proper placement. Store in a dry area, at room temperature to avoid freezing. To replace the powerbrush belt If the belt should break, to replace: 1. Remove the screw in the belt cover using a Phillips Screwdriver. 2. Remove the broken belt. 3.
Troubleshooting (continued) Dual PowerBrushes are not rotating Possible causes Remedies 1. Removable cartridge not inserted 1. Make sure to firmly "snap" the properly/all the way brush cartridge in place 2. Broken belt 2. Replace belt (page 9) Water coming out of vents Possible causes Remedies 1. Tank is past full line 1. Empty tank 2. Unit may be tipped upright causing dirty water to leak from collection tank 2.
Replacement parts Item 1 2 3 4 5 6 7 8 9 10 Part No. 203-2557 203-2552 203-2554 203-2514 203-2517 203-2537 79B9 79B9-1 74R7 74R7-1 Part Name Solution tank w/cap Collection/solution tank cap Collection tank w/cap Brush cartridge Belt Cover Belt 2X Little Green® Formula 32 oz. 2X Little Green® Formula 16 oz. 2X Pet Stain & Odor Formula 32 oz. 2X Pet Stain & Odor Formula 16 oz. 1 2 3 6 7/8 9/10 4 5 Please register your new BISSELL product at www.bissell.
Warranty - BISSELL Spot Lifter® PowerBrush This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. Keep your original sales receipt — it is your proof of warranty.
