Quick Installation Guide
Box Contents • Phenom Micro-ATX Case • Phenom Micro-ATX Quick Installation Guide o Accessories: USB 3.0 to 2.0 Apdater HDD Anti-vibration Washers x 4 Motherboard Standoff grip tool: x 1 (For loosening/tightening MB standoffs) Cable Ties: x 6 5.25" Drive Bay Adapter o Screws: Standard Screw M3*5mm Round: x 25 (For 2.5" SSD & MB tray) Motherboard Standoffs: x 9 (For MB) Thumbscrews M3: x 2 (For 5.25" Drive Bay Adapter) Standard Screw 6*6mm Round: x 16 (For 3.
Front Top Back Side Basic Installation Removing side panels b a a. Remove thumbscrews 02 b.
Installing 3.5" drives a. Remove hard disk tray a. Put drives into place b. Install drives using 6*6mm Round screws c. Secure hard disk tray with screws b.
Installing 2.5" drives a. Remove hard disk tray by removing screws b. Install drives c. Secure with screws (M3*5mm Round screws) d.
Installing 2.5" drives a. Slide drives into place b.
06 A A. SuperSpeed USB3.0 ports B B. Headphone jack C C. Microphone jack D D. Reset button E E.
Top Fan Installation (120mm) a. Remove top filter b. Install fans c. Secure with screws d.
Bottom Fan Installation (120mm) a. Install fans b. Secure with screws (Remove heat shield if installed) Bottom Fan Installation (230mm) a. Install fan 08 b.
Rear Fan Installation a. Install fan b.
PSU Installation a. Remove thumbscrew b. Remove PSU bracket c. Secure PSU with screws (Standard screw 6-32 hex) d.
Installing 5.25" drive bay adapter A B a. Install device using M3*5mm Round screws b. Use A or B depending on device c. Slide tray into place d.
Magnetic heat shield (Use when HDDs are installed on the bottom) Magnetic heat shield 12
Bitfenix Co., Ltd. 3F, No.79, Sec. 1, Xintai 5th Rd., Xi Zhi District, New Taipei City, Taiwan, R.O.C. For the most updated information, please visit our official website: http://www.bitfenix.com © 2013 BITFENIX Co., Ltd. All Rights Reserved. All trademarks are registered to their respective owners. Ver 1.
