User's Manual

21
Intercom Operations
Large Group Intercom (Three-parties or more)
You can daisy-chain multiple HBC200 units to form bigger group intercom. A chain of
10 or more parties is achievable.To setup group intercom, you must first allow all the
HBC200 units to recognize each other through the pairing process. Pairing process needs
to be carried out only once.
Pairing
1.Power off all the HBC200 communicators first.
2.Pick one unit as the 1st device, hold Answer and Down button for 5 seconds. The status
indicator would blink purple.
3.For the 2nd device, hold Answer and Up buttons for 5 seconds. The status indicator
would blink purple. Wait until the 1st device status indicator turns blue, then proceed to
pair the next device.
4.Hold 5 seconds Answer and Up buttons on the 3rd device, status indicator will blink
purple. Wait for the 2nd device status indicator to turn blue, then proceed to pair the next
device.
5.Repeat step 4 for all other units until all the devices are paired.
6.The last device will remain blinking purple. You can press any button on the device to
end the pairing process, the status indicator should turn blue.
It is recommended that after the pairing process is successful, restart all the helmet
communicators.
Start Intercom
•To start/connect the intercom, hold the Up button for 2 seconds.
•All the devices will be chained up automatically, in the sequence same as the pairing
process.
Stop Intercom
•To stop the intercom, hold the Down button for 2 seconds.
All the devices in the chain will be disconnected automatically.
Helmet 1 ( 1st device)
Hold Answer and Down Button
Helmet 2 ( 2nd device)
Hold Answer and Up Button
Helmet 3 (3rd device)
Hold Answer and Up Button
Helmet 4 ( 4th device)
Hold Answer and Up Button
and more……