User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 14 -
BGT-100P/102P
1-5-5 Check the orientation of the roll paper when inserting it into the printer.
1-5-6 Pull out a small amount of paper as shown in the picture, and close the cover.
※ CAUTIONS
When closing the cover, hold down the center of printer cover firmly so that paper roll is
loaded correctly.
1-5-7 Cut the paper as shown in the following picture.