User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 16 -
BGT-100P/102P
1-8 Removing Paper Jam
1-8-1 When a paper jam occurs, turn the printer OFF and then back ON, open the cover,
and remove the jammed paper.
※ In case of a minor jam, it may be possible that the operating blade returns to the
original position and cover can be opened simply by turning the printer OFF and
then back ON.
Follow the steps shown below if the cover does not open after power cycling.
1-8-2 Turn the printer OFF.
1-8-3 Separate the cover-cutter while pressing down both sides as shown in the following
picture.
1-8-4 Turn the knob and insert the blade that sticks out using a cross-head screwdriver as
shown below.
1-8-5 Press the Cover-Open button, open the cover, remove the jammed paper, and
assemble the separated COVER-CUTTER.
1-8-6 Turn the printer ON and use it.