User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 17 -
BGT-100P/102P
1-9 Adjusting Paper Near-end Sensor Setting
BGT-100P/102P printer has built-in near-end sensors that provides an alarm signal when
the paper has run almost to the end. BGT-100P/102P can be configured as wall mounted
or desktop operation and the settings of the paper near-end sensor should be adjusted
accordingly.
Adjust the near end sensor tab to either side so that the near end sensor is set properly for
wall mounted or desktop operation.
1-10 Using Printer Functions
Control Panel
○ POWER
Green light will be on when the power is supplied to printer after 10
seconds.
○ ERROR
Red light will be on in various error conditions (e.g. no paper, cover
open, etc.)
○ PAPER
Red LED will be lit when the paper roll is running low. The LED keeps
blinking when the printer is in self-test standby mode or macro execution
standby mode.
○ FEED
Press the FEED button once to feed out extra paper. Hold down
the FEED button to feed the paper continuously until the button is
released...
Near end sensor tab