User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 19 -
BGT-100P/102P
2. Self-Test
The self-test checks whether the printer has any problems. If the printer does not function
properly, contact your dealer. The self-test procedure is as follows:
2-1 Make sure paper roll has been installed properly.
2-2 Turn on the power while holding down the FEED button and the self-test begins.
2-3 The self-test prints the current status of the printer including control ROM version and
the DIP switch settings.
2-4 After printing the current printer status, the printer wait for the next step after printing
the following lines. (The paper signal light keeps blinking.)
SELF-TEST PRINTING.
PLEASE PRESS THE FEED BUTTON.
Continuous SELF-TEST : Less than 1 second
VMSM Selection : 1 second or more
2-5 Press the FEED button to resume printing or hold down the FEED button for 1 second
to set the virtual switch.
2-5-1 Self-Test
2-5-1-1 If you press the FEED button for less than 1 second, the printer will print in the
preset character type.
2-5-1-2 The self-test completes automatically and cuts the paper after printing the following
line.
*** COMPLETED ***
2-5-1-3 The printer goes into standby mode when the self-test is complete.