User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 20 -
BGT-100P/102P
2-5-2 Virtual Switch Setting Mode
2-5-2-1 When the printer goes into virtual switch-setting mode, the following lines will be
printed:
** VMSM Selection **
0: Exit and reboot printer
1: Print current settings
2: Set Print Density
3: Set Print Speed
4: Set Cutting mode
5: Set External Buzzer after cutting
6: Set Internal Buzzer after cutting
7 or more: None
2-5-2-2 Make sure to press the FEED button to perform the above functions.
2-5-2-2-1 Step 1: Press the button to make a selection.
2-5-2-2-2 Step 2: Hold down the button for at least 1 second to apply the selection.
If no selection is made in Step 1, the mode setting will be canceled.
2-5-3 After making changes, make sure to hold down the FEED button for at least 1
second to save the changes. The paper will be cut after printing the following line:
(“0: Exit and reboot printer” must be executed to save the settings on the printer.)
*** COMPLETED ***
2-6 The settings will take effect after the printer reboots.