User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 23 -
BGT-100P/102P
5. Appendix
5-1 Cleaning Printer
Paper dust inside the printer may lower the print quality. In this case clean the printer as
follows:
5-1-1 Open the printer cover and remove any paper.
5-1-2 Clean the print head with a cotton swab moistened with alcohol solvent.
5-1-3 Clean the paper sensor and paper roller with a cotton swab and a dry cloth.
5-1-4 Insert a paper roll and close the printer cover.
The remaining amount of paper detected by paper near-end sensor varies with the
diameter of the paper core. To set the paper near-end sensor, contact your dealer.