User's Manual
Table Of Contents
- 1. Installing Printer and Getting Started
- 1-1 Unpacking
- 1-2 Interface
- 1-3 Drawer Cable
- 1-4 Setting Dip Switches
- 1-5 Installing & Replacing Paper
- 1-6 Recommended Papers
- 1-7 Structure of 2 inches specification.
- 1-8 Removing Paper Jam
- 1-9 Adjusting Paper Near-end Sensor Setting
- 1-10 Using Printer Functions
- 1-11 Connecting a Computer
- 1-12 Connecting Power Supply
- 2. Self-Test
- 3. Hexadecimal Dumping
- 4. Specifications
- 5. Appendix
Rev. 1.00
- 9 -
BGT-100P/102P
1-2 Interface
Connect the printer to the host computer using the right interface cable that complies with
the specifications of the interface. The drawer to be used with the printer should meet the
specifications of the printer.
※ CAUTIONS
Before connecting any cables, make sure that both the printer and the host are
turned off.
1-2-1 USB Interface(Host Function USB A type connector)
USB Interface can connect to the peripheral devices.
(ie. the barcode reader, customer display and WLAN Dongle that is supported by the
printer.)
Pint No.
Signal Name
Designation (Color)
Function
Shell
Shield
Drain Cable
Frame Ground
1
VBUS
RED
Host Power (+5VDC)
2
D-
WHITE
Data Line (D-)
3
D+
GREEN
Data Line (D+)
4
GND
BLACK
Signal Ground
* Do not connect the USB A-A type cable with the Printer and HOST(ex. PC)
* ② USB A-type connector and “HOST (PC)” USB B-type connector cannot be used at
the same time. Make sure you use only one of them
USB A Connector(Host Function)
②
①