User's Manual
Table Of Contents
- ※ Manual Information & Usage Precautions
- 1. Content Confirmation
- 2. Product Part Names
- 3. Installation & Usage
- 4. Self-Test
- 5. Detailed features
- 5-1 Printer setting using utility program
- 5-2 Stand-alone Configuration Mode
- 5-3 Pause/Cancel
- 5-4 Media Calibration
- 5-5 Smart Media Detection
- 5-6 Gap Sensor Auto Calibration Mode
- 5-7 Black Mark Sensor Auto Calibration Mode
- 5-8 Manual Calibration Mode
- 5-9 Cover Closing Mode
- 5-10 Data Dump Mode
- 5-11 Factory Reset
- 5-12 The Peel-Off (Option)
- 5-13 Using Fan-Fold Paper
- 5-14 Auto Cutter (Option)
- 5-15 Real-Time Clock (Option)
- 6. Bluetooth Connection (iOS,Android)
- 7. Cleaning Head
- 8. Appendix
Rev. 1.00
- 13 -
SLP-TX420B/TX423B
3-2 Interface Cable Connection
3-2-1 Bluetooth Model
Connect the interface cable as shown below.
This printer supports the following communications interface standards.
- USB A-Type(WLAN Dongle)
- USB B-Type Cable
1) Turn off the power switch.
2) Connect the communication cable to the printer communication port to be used.
- Connect USB A-Type(WLAN Dongle) to the HOST port.
- Connect USB B-Type cable to the USB port.
(This port requires a shielded cable less than 1.8m long.)
- It can connect by internal Bluetooth module.
USB
B-Type Cable
USB
A-Type
(WLAN Dongle)