User's Manual
Table Of Contents
- ※ Manual Information & Usage Precautions
- 1. Content Confirmation
- 2. Product Part Names
- 3. Installation & Usage
- 4. Self-Test
- 5. Detailed features
- 5-1 Printer setting using utility program
- 5-2 Stand-alone Configuration Mode
- 5-3 Pause/Cancel
- 5-4 Media Calibration
- 5-5 Smart Media Detection
- 5-6 Gap Sensor Auto Calibration Mode
- 5-7 Black Mark Sensor Auto Calibration Mode
- 5-8 Manual Calibration Mode
- 5-9 Cover Closing Mode
- 5-10 Data Dump Mode
- 5-11 Factory Reset
- 5-12 The Peel-Off (Option)
- 5-13 Using Fan-Fold Paper
- 5-14 Auto Cutter (Option)
- 5-15 Real-Time Clock (Option)
- 6. Bluetooth Connection (iOS,Android)
- 7. Cleaning Head
- 8. Appendix
Rev. 1.00
- 27 -
SLP-TX420B/TX423B
5-7 Black Mark Sensor Auto Calibration Mode
Use this mode when paper is not detected correctly with Smart Media Detection function.
Printer feeds paper and calibrates Black Mark Sensor automatically.
The printer will enter error mode if paper detection fails after feeding up to 2 meter of paper.
Error mode can be released by opening and closing the cover.
Use Manual Calibration Mode if paper detection fails in this mode.
Smart Media Detection will be disabled if paper detection is successful in this mode.
5-7-1 Procedure to run calibration
• Press the Feed button at 5th LED sequence as shown in section 5-2-2 (LED 1
is Orange and LED 2 is blinking Orange four times) to start Black Mark Sensor
Automatic Calibration Mode.