User`s manual

Rev. 1.00
- 16 -
SRP-270
3-1 Serial Interface
SW FUNCTION ON OFF DEFAULT
1 OFF
2
Emulation Selection
Refer to the following
table
OFF
3 Auto-Cutter Enable Disable OFF
4 FONT SPACE 2 3 OFF
5 -
6 -
7
Function for
Service Engineer
OFF
8 Buffer size 40Bytes 4KBytes OFF
DIP switch Setting 1 Function
SW – 1 SW – 2 MODE
OFF OFF EPSON
OFF ON Citizen
ON OFF Star
Emulation Selection
SW FUNCTION ON OFF DEFAULT
1 Auto Line Feed
Always
Enabled
Always
Disabled
OFF
2 Hexadecimal dump YES NO OFF
3 Hand Shaking XON/OFF DTR/DSR OFF
4 Word length 7 bits 8 bits OFF
5 Parity check Enable Disable OFF
6 Parity selection EVEN ODD OFF
7 OFF
8
Baud Rate selection
Refer to the following
table
OFF
DIP switch Setting 2 Function
Transmission speed SW – 7 SW – 8
19200 BAUD ON ON
2400 baud OFF ON
4800 baud ON OFF
9600 baud OFF OFF
Baud Rate selection
NO※ TE
When the word length is 7 bits, you can not parity check OFF status.