User`s manual
Table Of Contents
- 1. Setting Up the Printer
- 1-1 Unpacking
- 1-2 Connecting the Cables
- 1-3 Connecting the Drawer
- 1-4 Setting the Dip Switches
- 1-5 Setting the Memory Switches
- 1-6 Installing or Replacing the Paper Roll
- 1-7 Adjustments and Settings
- 1-8 Using the Printer
- 1-9 Connecting the computer
- 1-10 Connecting the Power Supply
- 2. Self test
- 3. Hexadecimal Dumping
- 4. Specification
- 5. Appendix
Rev. 1.04
- 11 -
SRP-350plusA&C
1-4 Setting the Dip Switches
1-4-1 Serial Interface (RS-232C)
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2 Handshaking XON/XOFF DTR/DSR OFF
1-3 Data Length 7bits 8bits OFF
1-4 Parity Check Yes No OFF
1-5 Parity Selection EVEN ODD OFF
1-6 OFF
1-7 ON
1-8
Baud Rate Selection
(bps)
Refer to the following table 1
OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Reserved - - OFF
2-2 Internal bell control
Internal bell
disable
Internal bell
enable
OFF
2-3 Auto Cutter Disable Enable OFF
2-4 BUSY Condition Receive Buffer Full
* Offline
* Receive Buffer
Full
OFF
2-5 OFF
2-6 OFF
2-7
Print Density Refer to the following table 2
OFF
2-8 Near-End Sensor Status Disable Enable OFF
1-4-2 Parallel & USB2.0 Interface
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2
~
1-8
Reserved - - OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Reserved - - OFF
2-2 Internal bell control
Internal bell
disable
Internal bell
enable
OFF
2-3 Auto Cutter Disable Enable OFF
2-4 BUSY Condition Receive Buffer Full
* Offline
* Receive Buffer
Full
OFF
2-5 OFF
2-6 OFF
2-7
Print Density Refer to the following Table 2
OFF
2-8 Near-End Sensor Status Disable Enable OFF