User`s manual
Table Of Contents
- 1. Setting Up the Printer
- 1-1 Unpacking
- 1-2 Connecting the Cables
- 1-3 Connecting the Drawer
- 1-4 Setting the Dip Switches
- 1-5 Setting the Memory Switches
- 1-6 Installing or Replacing the Paper Roll
- 1-7 Adjustments and Settings
- 1-8 Using the Printer
- 1-9 Connecting the computer
- 1-10 Connecting the Power Supply
- 2. Self test
- 3. Hexadecimal Dumping
- 4. Specification
- 5. Appendix
Rev. 1.04
- 12 -
SRP-350plusA&C
• Table 1 – Baud rate (bps) Selection
Transmission Speed 1-6 1-7 1-8 Default
2400 ON OFF OFF
4800 ON OFF ON
9600 OFF ON OFF
19200 OFF OFF OFF
38400 OFF ON ON
57600 OFF OFF ON
115200 ON ON ON
9600
• Table 2 – Print Density Selection
2-5 2-6 2-7 Print Density (Mono color) Default
ON ON Reserved 1(Light)
OFF OFF Reserved 2
ON OFF Reserved 3
OFF ON Reserved 4(Dark)
2
2-5 2-6 2-7 Print Density (Two colors ) Default
ON ON ON 80%
ON ON OFF 90%
OFF OFF ON 95%
OFF OFF OFF 100%
ON OFF ON 105%
ON OFF OFF 110%
OFF ON ON 120%
OFF ON OFF 130%
100%
1-4-3 Auto Cutter Enable / Disable selection
Dip Switch Set 2
ON Auto Cutter Disabled
SW 2-3
OFF Auto Cutter Enabled
Application Ignores Auto Cutter error for continuous printing.