User`s manual
Table Of Contents
- 1. Setting Up the Printer
- 1-1 Unpacking
- 1-2 Connecting the Cables
- 1-3 Connecting the Drawer
- 1-4 Setting the Dip Switches
- 1-5 Setting the Memory Switches
- 1-6 Installing or Replacing the Paper Roll
- 1-7 Adjustments and Settings
- 1-8 Using the Printer
- 1-9 Connecting the computer
- 1-10 Connecting the Power Supply
- 2. Self test
- 3. Hexadecimal Dumping
- 4. Specification
- 5. Appendix
Rev. 1.04
- 19 -
SRP-350plusA&C
2. Self test
The self-test checks whether the printer has any problems. If the printer does not function
properly, contact your dealer. The self-test checks the following;
2-1 Make sure paper roll has been installed properly.
2-2 Turn on the power while holding down the FEED button. The self-test begins.
2-3 The self-test prints the current printer status, which provides the control ROM version
and the DIP switch setting.
2-4 After printing the current printer status, self-test printing will print the following,
and pause (The PAPER LED light blinks).
Self-test printing.
Please press the FEED button
2-5 Press the FEED button to continue printing.
The printer prints a pattern using the built-in character set.
2-6 The self-test automatically ends and cuts the paper after printing the following.
*** COMPLETED ***
2-7 The printer is ready to receive data as soon as it completes the self-test.