SRP - 770 Thermal Label Printer Operator’s Manual JE68-00131B http://www.samsungminiprinters.
Safety Precautions In using the present appliance, please keep the following safety regulations in order to prevent any hazard or material damage. WARNING WARNING Violating following instructions can cause serious injury or death. Do not plug several products in one multi-outlet. You must use only the supplied adapter. It is dangerous to use other adapters. This can provoke over-heating and a fire. If the plug is wet or dirty, dry or wipe it before usage.
1. Unpacking 2. Samsung Label Printer Your printer box should include these items. If any items are damaged or missing, please contact your dealer for assistance.
3. Connecting the Power Supply 4. Connecting the Interface Cable CAUTIONS: When connecting or disconnecting the power supply from the printer, make sure that the power supply is not plugged into an electrical outlet. And the power supply’s rated voltage and your outlet’s voltage do not match, contact your dealer for assistance. Then do not plug in the power cord. Otherwise, you may damage the power supply or the printer. 1.
. Installing or Replacing the Paper Roll 6. Setting The Dip Switches 6-1. Setting the Dip Switches ① Open Cover ② Open Guides The Dip Switches are located on the bottom of the printer. The Dip Switches are used to set the Printer to perform various functions. Follow these steps when changing Dip Switches setting : 1. Turn the printer power switch off. 2. Remove the screw on the bottom of the printer and open the bracket. 3. Flip the Dip Switches using tweezers or another narrow-ended tool.
7. The Self Test 8. The Peel-off (and Autosense Gapsensor Adjustment) The self-test checks whether the printer has any problems. And perform this procedure when loading a new roll.(You cannot perform this procedure if using the printer’s label peel-off option) If the printer does not function properly, contact your dealer. The self-test checks the following; 1. Make sure that paper roll has been installed properly. 2. Turn on the power while holding(2sec) down the FEED button. The self-test begins. 3.
9. Using Fan Fold Paper 【 Specification 】 Insert paper through both the rear slot and guides. Adjust holders and guides to the width of the paper. Open the Dust Cover and Insert paper Dust Cover Adjust holders papers and paper Fixed Printing method Thermal line printing Dot density 203 dpi (8 dot/mm) Printing width 25.4 ~ 101.6 mm Paper width 38.
