User's Manual

14
www.cmaxwireless.co.kr
This step is for setting both CMAX Module and your PC to be located the same network.
If only they are, the TCP connection between them can be established.
l Setting of the PC
Add or change the IP address of the network adapter on your PC like following.
Get into the menu of [Windows Control Panel] >> [Network Connections] >> [Properties
of the Network Adapter - with right click of your mouse]. Then, you can show the
properties of [Internet Protocol (TCP/IP). In there, press the [Advanced] button for adding
an IP Address like the below figure.
[Figure 2.2.2.1] Adding / Changing the IP address of users’ PC (example)
l Setting of CMAX Module
CMAX Module uses WLAN Module Manager as it’s a configuration program. WLAN
Module Manager is for MS Windows, and this is comfortable to use because it doesn’t
need installation. First, search your WLAN Module via network. All the values of
parameters are set the default values in the factory. To apply it to your system, proper
values should be set via WLAN Module Manager. Major parameter’s default values are
listed on below table. To implement this simple test, keep these values without any
changes.
DISTRIBUTION
FUNCTION
VALUE
System
User ID
admin
User Password
password
Protocol
FTP
Disable
TELNET
Disable
HTTP
Enable / HTTPS is disable
SNMP
Disable
Community Name (Read) : Public
Community Name (Write) : Private
Trap Destination IP Address : 0.0.0.0
Trap Destination Community Name : Public
Trap Mode : 1 (Enable), 0 (Disable)
Network
Locality
Disable