User's Manual

www.cmaxwireless.co.kr

7.4 Labeling

l FCC ID: U5MWD-MSB

The proposed with FCC ID label format is to be placed on the module. If FCC ID is not

visible when the module is installed into the system, “Contains FCC ID:U5MWD-MSB ”

shall be placed on the outside of final host system.

l Caution: Exposure to Radio Frequency Radiation.

To comply with FCC RF exposure compliance requirements, a separation distance of at

least 20 cm must be maintained between the antenna of this device and all persons.

*The module is limited to OEM installation only.

OEM integrators must ensure that the end-user has no manual instructions to remove or install the

module. OEM's must comply with FCC marking regulation part 15 declaration of conformity

(Section 2.925(e)).

This module is to be installed only in mobile or fixed applications (Please refer to FCC CFR 47 Part

2.1091(b) for a definition of mobile and fixed devices).

The separate approval is required for all operating configurations, including portable configurations

with respect to FCC CFR 47 Part 2.1093 and different antenna configurations.

The WD-MSB Module has been designed to operate with the following antenna and gains. Use with

other antenna types or with these antenna types at higher gains is strictly prohibited.

Manufacturer

Type of

Antenna

Model

Gain (dB)

Type of Connector

Nice Korea

Components Co.,

Ltd

Chip Antenna

NKCBTF-F02

3.91

Permanent

integral

For more information, visit our website at http://www.cmaxwireless.co.kr