Installation Manual

2. If you do not have the CD, you can download the scanner driver from www.bizcardreader.com. After you
download the driver, note the folder where the downloaded driver file is saved.
3. Unplug the USB cable from the scanner for a few seconds and then plug it back in.
4. If the system new hardware wizard is displayed, then follow the steps described in the previous section to
install the scanner driver. Otherwise go on to the next step.
5. Start up the Windows Device Manager. You can find the Device Manager as follows:
a. In Windows 7 or 10, click on the Windows start icon on the bottom left corner of the desktop, and type
in “Device Manager” in the Search box.
b. In Windows 8, click in the Search icon found at the top right corner of the Windows START screen,
and type in “Device Manager”.
6. You can also start up the Device Manager from the Control Panel - in the Control Panel, select System and
Security and then click on the System icon. Then select Device Manager (usually on the top left, just below
Control Panel Home). The Device Manager screen will be displayed.
7. In the Device Manager screen, look under Imaging Devices, and locate the BCR901 or DX1210 card scanner.
a. If you see the BCR901 or DX1210 card scanner under Imaging Devices, RIGHT click on the scanner,
and select properties. If the Device Status (in Properties) shows the device working properly, the
driver installation is successfully completed. Close and exit the Device Manager, and the scanner
is ready for use.
b. If you see the BCR901 or DX1210 scanner with an exclamation mark beside it, highlight it and RIGHT
click to select Update Driver Software. Follow the instructions to search/locate the “drivers” folder on
the Application CD (or the folder where you saved the downloaded driver file). Click Finish after the
driver is installed.
c. If you do not see the scanner under Imaging Devices, look in the same Device Manager screen for
“Unknown Device” under “Other Devices”. Highlight the Unknown Device, and RIGHT click on it to
select Update Driver Software. Follow the instructions to search/locate the “drivers” folder on the
Application CD (or the folder where you saved the downloaded driver file). Click Finish after the driver
is installed.
8. Upon successful installation of the device driver, the Device Status described above should show the device
working properly.