Instruction Manual

USA FCC/ Canada IC Requirements:
If following “WiFi/ Bluetooth Antenna Requirements” (with or without colocated LTE module) and
“Colocated LTE Antenna Requirements“ (when final product is equipped with colocated LTE
module) cannot be met, the FCC/IC authorization will not be considered valid and it is prohibited
to use current FCC ID/IC ID on the final product. In these circumstances, the OEM integrator is
responsible for reevaluation of the end product, including the transmitter to obtain a separate
FCC/IC authorization.
WiFi/Bluetooth Antenna Requirements:
•
Final product shall operate only using antenna of a type and maximum (or lesser) gain listed
in Table 1. Antenna types not included in the list or having a gain greater than the maximum
indicated are strictly prohibited for use with this transmitter.
•
When WiFi/Bluetooth transmitter module is not colocated with LTE cellular module, the
antenna must be installed so that the minimum separation distance of 20 cm is maintained
between the antenna and users.
•
When WiFi/Bluetooth transmitter module is colocated with LTE cellular module, the antenna
must be installed so that the minimum separation distance of 22 cm is maintained between
the antenna and users.
Table 1. Approved Antenna Types and Maximum Gain Values for WiFi/Bluetooth Antenna
Antenna Type
Brand
2.4 GHz
4.9 to 5.9 GHz
Unit
PCB
Ethertronics
–0.600
4.50
dBi
Dipole
LSR
2.00
2.00
PCB
Laird
2.00
4.00
Chip
Pulse
3.20
4.20
PIFA
LSR
2.00
3.00
Chip
TDK
2.27
3.96
BK Electronic Design Inc.
www.bkelectronicdesign.com
Page  of 3 5