Specifications

① When [FREE] is selected, the program is read (i.e., run) and a delay of the pause time is created.

This is repeated continuously.

② When [GATE] is selected, the program read and pause times are repeated while the signal input to

terminal TRIG IN is TTL High or while the <ENTER> is pressed (and held).

③ When [BURST] is selected, program read is executed at the rising edge of the signal applied to

terminal TRIG IN or when the <ENTER> key is pressed. The pause time value is ignored.

4.8 SET UP

① The setup is used for the configuration of communication parameters. The screen below appears

when the <SET UP> key is pressed.

ＳＥＴ　ＵＰ：

ＲＳ２３２Ｃ　ＧＰＩＢ　ＥＸＩＴ

②When RS-232C is selected, the following screen is displayed.

Select the baud rate of RS-232C using the rotary knob and confirm with the <ENTER> key.

(2400, 4800, 9600, 19200, 38400, 57600)

ＳＥＴ　ＵＰ　－　ＲＳ２３２Ｃ

ＢａｕｄＲａｔｅ：　５７６００

③When GPIB is selected, the following screen is displayed.

Select the GPIB address (0 - 30) using the rotary knob and confirm with the <ENTER> key.

ＳＥＴ　ＵＰ　－　ＧＰＩＢ

ＡＤＤＲＥＳＳ：　１０