Instruction manual

6. Command : OUTPut[:STATe]<SP>ON <Channel_list>
Description : Set the Output relay to ON state for the specified channels.
Function : This command is used to switch on the output relay & thus to
make the OUTPUT available at the output terminals.
7. Command : OUTPut[:STATe]<SP>OFF<Channel_list>
Description : Set the Output relay to OFF state for the specified channels.
Function : This command is used to switch OFF the output relay & thus to
disconnect the OUTPUT available at the output terminals.
8. Command : SYSTem:REMote
Description : Takes the instrument into Remote Mode of operation
Function : This command will explicitly take the unit to remote mode. All the
front panel controls are disabled. It is advisable to put the unit
into REMOTE mode of operation using this command, before
using the instrument in Remote mode.
9. Command : SYSTem:LOCal
Description : Take the instrument to Local mode of Operation.
Function : This command will take the unit to Local mode of operation &
ALL the front panel controls are enabled.
6.9 IEEE-488 COMPLIANCE INFORMATION
Dedicated Hardware Lines: Universal Commands:
ATN Attention DCL Device Clear
IFC Interface Clear ATN Attention
REN Remote Enable IFC Interface Clear
SRQ Service Request Interrupt LLO Local Lock-Out
Addressed Commands:
SDC Selected Device Clear
END End Message
GTL Go to Local
55