Owner`s manual

40 BK Radio Programming Manual
Digital or Mixed, or if User Channel Guard is activated.
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

00659
TX NAC
To see the NAC displayed in hexadecimal
format, press and hold the [#] key.
To return to the decimal display, press and
hold the [#] key again.
If the NAC is correct, press the [FCN] key to advance to the next eld.
If a new NAC is desired, press the [CLR] key
In decimal mode, valid entries are 0 – 4095. The values 3966 and 3967
are reserved for receivers and cannot be entered.
In hexadecimal mode, valid entries are $0 - $FFF. The values $F7E
and $F7F are reserved for receivers and cannot be entered.
To enter hexadecimal characters A - F:
Each long press of the [2] key toggles the rightmost character from A to
B to C, then back to A.
Each long press of the [3] key toggles the rightmost character from D
to E to F, then back to D.
To enter a ‘letter’ after another ‘letter’ or number, rst enter any
number, then toggle it with long [2] or [3] key presses.
NOTE: To enable User NAC Pick List Selection, press and hold the ‘U’
key “[8] key”. The display will show “UNAC EN”. To disable Pick List
Selection, press and hold the ‘U’ key again. If Pick List Selection is
enabled, but none of the entries has been selected, the radio will use
the default NAC ($293) when transmitting in digital mode.
Press [ENT] to store and return to the next value.
Talk Group ID (Digital models only)
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

00001
TALK GRP ID
This eld is the Talk Group ID. This value is
only used if the transmit mode selected was
Digital or Mixed, or if User Channel Guard is
activated. The upper part of the display will
show ‘PRG’.
If the displayed value is correct, press the [FCN] key to advance to the
next eld.
If you wish to change it, press the [CLR] key followed by the digits for
the new TGID, then [ENT] to store the new value and automatically
advance to the next eld. Valid entries are 1– 65535.
Contents