Owner`s manual
2 BK Radio Programming Manual
Entering the Programming Mode
NOTE: Specic settings may be blocked from keypad programming
when using the Group or Zone password. Using the Master password
overrides these selections and allows for access to all programmable
functions.
Portable Radios
Make sure the battery pack is charged.
Some models are shipped with a door covering the keypad and display.
Before programming, remove the door by removing the battery pack,
engaging the door just below the speaker grill, and sliding the door
downward.
ch 01
Digital
-- -- id
Master Switch
Programming
Plug
Insert the programming plug into the side
connector of the radio. The push-button
master switch will be on the top.
NOTE: The cloning cable can be used
as a substitute for the programming plug
by inserting the end with the push-button
master switch into the side connector of the
radio.
Select a channel group to be programmed
See “Select A Group/Channel” in the
Owner’s Manual.
Press and hold the master switch.
While holding the master switch, press and hold the [FCN] key. After
approximately three seconds the LCD will display ‘- - - ID.’
Release the [FCN] key and the master switch. The radio is now in the
Password Entry Mode.
Enter the six-digit password code for the selected group. Without the
correct password code, you cannot proceed with programming.
NOTE: New radios shipped from the factory are assigned the
password code 000000.
CH 00
PRG
Press the [ENT] key to proceed to
Programming Mode. The display will change
to PRG CH 00.
Contents