Service manual

Installation and Programming GPH-CMD VHF Radio
Page 2-14 BK RADIO
Master
Clone
Master
Switch
When receiving an incoming clone from a GPH radio, the GPH-CMD radio
ignores group data other than the group label and the group scan list bit.
The GPH-CMD’s global data and channels 17-20 are not disturbed.
NOTE: Some groups may be “locked” by PC programming to prevent them
from being overwritten. Only “unlocked” groups will accept incoming
clones.
1. Make sure the battery packs for both radios are charged.
2. Attach the master switch end of the cloning cable to the side connector
of the Master radio.
NOTE: One plug of the cloning cable has a push-button master
switch. This plug must be attached to the Master radio.
3. Turn on the Master radio.
4. Put the Master radio in Programming Mode by pressing and holding the
master switch then pressing and holding the [FCN] key until the display
shows ‘PSWRD-******’. Enter the 6-digit password. The display shows
‘PROG CH 00.’
5. Connect the other plug of the cable to the side connector of the radio
you want to clone.
6. Turn on the clone and set it to the desired channel group.
7. Press the [*] key on the Master radio keypad. The radio will respond
showing the prompt ‘PROG|GPHCMD’ on the first line and ‘Group XX’
on the second line, where XX is the currently selected group (see Select
A Group/Channel, section 3.8 of this manual, for details of how the
group is selected).
Long [*] keypresses will toggle the first line of the display between
PROG|GPHCMD’ and ‘PROG|GPH’, if the second line of the display
shows data that is valid to copy to the displayed target.
Data Valid Target
GROUP 00 GPHCMD only
GROUP 01 - 25 GPHCMD, GPH
CMND GRP GPHCMD, GPH
PICK LIST GPHCMD only
8. Long [#] keypresses will cause the second line of the display to cycle
through the data blocks that can be transferred to the target displayed on
the first line.
Target Valid Data
GPHCMD
GROUP 00 or GROUP 01 - 25
CMND GRP
PICK LIST
GPH
GROUP 01 – 25
CMND GRP
PSWRD-******
PROG
ch 00
PROG|GPHcmD
Group 01
PROG|GPH
Group 01
Press and Hold [*] Key
to Change Target
PROG|GPHcmD
cmnd group
PROG|GPHcmD
pick list
Press and Hold [#] Key
to Chan
g
e Data