Installation Instructions
Table Of Contents
- Introduction
- FCC Requirements
- Innovation, Science and Economic Development Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- BK Technologies Warranty Information
- My Radio Settings
BK Technologies
- 58 -
Add Channel
Select to add a new channel.
Choose the zone to which the channel is to be added.
Enter a valid channel index number of 1-5000.
NOTE: To access channels above channel sixteen, the radio must be
programmed via PC for keypad channel select or “Channel Select”
must be assigned as a button or menu item.
Delete Channel
When selected the list of programmed zones is displayed. Choose the
zone of the channel you wish to delete.
Select the channel from the list.
Edit Channel
Select “Edit Channel” to change the programmable channel
information.
Select the zone and channel to be edited.
Channel Label
Use the keypad to enter a label of up to sixteen characters.
(See keypad character table)
Rx Frequency
Enter a valid receive frequency in MHz. Frequencies must be
divisible by 1.25kHz.
Rx Mode
Select Analog, Digital or Mixed Mode.
Rx Guard
Analog or Mixed Mode Receive Channels Only
Select “O” for analog signals to operate in carrier squelch mode.
Select “Tone” to enter a CTCSS tone,
Select “Digital” to enter a DCS value.
Use “INV” to invert a DCS tone.
RX NAC
Digital or Mixed Mode Receive Channels Only
Select “Enter” to program a receive NAC via the keypad.
Enter the desired value in hexadecimal (000 - FFF).