Installation Instructions
Table Of Contents
- Introduction
- FCC Requirements
- Innovation, Science and Economic Development Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- BK Technologies Warranty Information
- My Radio Settings
BKR9000 Portable Radio User’s Manual
- 57 -
Delete Zone
When selected the list of available zones is displayed. Choose the
zone you wish to delete.
When a zone is removed all subsequent zones move up one spot.
Example: If there are seven zones in the radio and zone ve is
deleted, zone six now becomes zone ve and zone seven becomes
zone six.
Edit Zone
Select “Edit Zone” to change the programmable zone information.
Zone Label
Use the keypad to enter a label of up to sixteen characters.
(See keypad character table)
Zone Priority 1 or 2 Channel
NOTE: If system priority channels are programmed, zone priority
settings are ignored.
When set to “O”, the Priority 1 or Priority 2 Channel is designated
by the selected zone setting.
When set to “Use Main” the channel selected by the channel knob
operates as the priority channel.
To designate a specic priority channel choose “Select” from the
priority channel menu and choose from the channel list.
Zone Tx Priority 1 Channel
If on, the radio will transmit on the Zone Priority 1 channel
whenever Priority Scan is on and there is no system priority 1
programmed.
Channel Settings
To edit the programmable Channel settings, select “Keypad” from the
programing menu then select “Channel” from the sub-menu.
Select Add, Delete or Edit Channel from the Channel menu.
NOTE: REFER TO THE COMMAND ZONE OPERATIONS SECTION
FOR ADDING OR DELETING COMMAND ZONE CHANNELS.
DO NOT ADD OR DELETE COMMAND ZONE CHANNELS VIA THE
KEYPAD PROGRAMMING METHOD.