Installation Instructions
Table Of Contents
- Introduction
- FCC Requirements
- Innovation, Science and Economic Development Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- BK Technologies Warranty Information
- My Radio Settings
BKR9000 Portable Radio User’s Manual
- 59 -
NOTE: $F7F is an invalid receiver NAC.
Choose “Select” to use a receiver NAC from the programmed pick
list.
Squelch Mode
Digital or Mixed Mode Receive Channels Only
Normal - Requires carrier and NAC only to unmute digital
signals.
Selective - Required for Individual Calls and use of Talkgroup
IDs. Requires a matching TGID to unsquelch.
Bandwidth
Analog or Mixed Mode Channels Only
Narrowband - 12.5kHz spacing when operating in analog.
Wideband - 25kHz spacing when operating in analog.
Tx Power
Low Power - Lock channel in low power mode.
High Power - Lock channel in high power mode.
Selectable - Allow high/low transmit power selection form
assigned button, switch or menu item.
Tx Frequency
Enter a valid receive frequency in MHz. Frequencies must be
divisible by 1.25kHz.
Tx Mode
Select Analog, Digital or Selectable.
Tx Guard
Analog or Mixed Mode Receive Channels Only
Select “O” for analog signals to operate in carrier squelch mode.
Select “Tone” to enter a CTCSS tone,
Select “Digital” to enter a DCS value.
Use “INV” to invert a DCS tone.
Tx NAC
Digital or Mixed Mode Transmit Channels Only
Select “Enter” to program a transmit NAC via the keypad.
Enter the desired value in hexadecimal (000 - FFF).