Installation manual

APPENDIX NO 1
BKI INSTALLATION CHECKLIST FOR COMBI KING OVENS
To be filled out at each installation of a BKI oven.
In order for the oven to qualify for warranty, this check list must be filled out by the service engineer installing
the oven and returned to BKI within 30 days of the date of
installation.
Serial No:__________Installed by:____________________________Date of installation:____________
The installation was carried out not carried out on the basis of the requirements specified in the
service and installation manual, please tick. If the measurements do not correspond with the values stated
in the service and installation manual, your BKI
distributor should be notified.
We confirm that the installation has been carried out on the basis of the attached check list and in
compliance with the rules/requirements applying in the country/area in question. When the oven was
handed over, it was free from any kind of defect.
______________________________________
_____________________________________
Service Engineer: Signature / Date Customer: Signature / Date
Send this form by e-mail to: [e-mail] or fax it through at [phone].
Access to the oven:
Left Side Minimum 50 mm (2”)
Rear Side Minimum 50 mm (2”)
Right Side Minimum 400 mm (15”)
All Ovens Distance Measured in mm
Drain Connection:
Heat-resistant drain tube connected.
Fall of at least 3° or 5%
CombiPlus fitted with open drain for both ovens.
The drain must never end directly beneath the oven.
Voltage and Water Supply:
(Please insert the measured value)
Voltage measured at:
Water Pressure measured at: (minimum 2 bar/28,5 psi - maximum 6 bar/88 psi)
Does the voltage on site comply with the voltage stated on the approval plate?
Dirt filter fitted?
Function Test:
All electrical connections are tight?
All water connections are tight and have been fastened?
All functions are operable?
All equipment is operable?
YES
YES
YES
YES
YES
YES
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
NO
NO
21