Installation manual

3
Approval Plate
When communicating with BKI, we kindly ask you inform us of the
serial number of the oven that is stated on the approval plate. The
approval plate is usually located on the oven cabinet, behind the
oven door, as shown.
BKI Technical Support, whose experience and expert knowledge
are
at your disposal, can be contacted at [phone].
APPROVAL
PLATE
INSTALLATION & CONNECTION
Unpacking the oven
The oven is best handled while still in its wrapping. Wherever
possible, use a lifting trolley.
Introduce the lifting trolley under the lower cross tube of the stand
and place a couple of wooden blocks between the cross tube and
the lifting trolley.
To achieve the best
possible balance, introduce the lifting trolley
from the front of the oven or from the motor side. Note that the oven
can be lifted off the stand.
Remove the original packaging from the oven. Do not remove the
foil that covers the surfaces until the oven has been installed, as
once
the foil has been removed the surfaces are vulnerable to
sharp objects such as tools.
Remove all packaging material that secures the racks in the oven
chamber.
NOTE:
BKI er
The packaging should be destroyed in accordance with national rules and
regulations governing waste disposal. Information on the composition of the
packaging material can be obtained from the Customer Cent .
!
!
Installing the oven
To ensure that the oven functions correctly when installed, it should be placed upright and level
(horizontally). This is measured at the front and side edge of the roof, and adjustment is made by means of
the adjusting screws on the stand or on the legs of table
models. The height of the oven can also be adjusted
to fit the trolley for rack.
CORRECT