Technical data

BKI 09 ATEX 0003X  htk4014a0600p_01.doc  3 / 80
CONTENTS
1. INTRODUCTION.............................................................................................5
2. ORDER CODE................................................................................................6
3. TECHNICAL DATA.........................................................................................7
3.1 Accessories ............................................................................................ 14
3.2 Safety regulations for the Ex approved units.......................................... 14
3.3 Maintenance and repair.......................................................................... 14
4. MECHANICAL INSTALLATION...................................................................15
4.1 Handling and storage .............................................................................15
4.2 Mounting on the tank .............................................................................. 18
4.2.1 Installation instructions: general notes ...........................................18
4.2.2 Specific installation instructions: gauge - solid applications...........24
4.3 Wiring......................................................................................................26
4.3.1 BUS ( HART
®
) communication.......................................................30
4.4 Power-on and start-up ............................................................................ 31
4.5 Available user interfaces ........................................................................31
5. PROGRAMMING...........................................................................................32
5.1 Programming with PCSTAR 2 software..................................................32
5.1.1 PCSTAR 2: installation and execution............................................32
5.1.2 Summary of User Functions in PCSTAR 2 (F2 – Configuration)....36
5.1.3 Quick Configuration: configuration examples..................................42
5.2 Programming with SAP-300 display unit................................................49
5.2.1 SAP-300 display unit.......................................................................49
5.2.2 MicroTREK’s behaviour in manual programming mode .................50
5.2.3 Manual programming......................................................................51
5.3 Programming with HART
®
handheld (HHC) Communicator ...................52
5.3.1 Characters available for alpha-numerical data functions
in PCSTAR2 and on the HART
®
console........................................62
5.4 MicroTREK 2-wire T.D.R. meter characteristics .....................................63
5.4.1 Gauge operating logic when the reflection is lost ...........................65
5.4.2 Gain and voltage amplitude ............................................................66
5.4.3 Typical signal trends........................................................................70
5.4.4 Automatic adjustment......................................................................71
5.4.5 Level measurement when
more than one phase or layer in the tank........................................73
5.5 Troubleshooting ......................................................................................75
5.6 Appendix 1 – Set-up parameters
of MicroTREK H-400 series in Multicont controller .................................79