Warming Station MODELS WS-13 and WS-15ST(C) Operation and Installation Manual WS-13 WS-15STC
BKI LIMITED WARRANTY PO Box 80400 • Simpsonville, SC 29680-0400 • USA (864) 963-3471 • Toll Free: (800) 927-6887 • Fax: (864) 963-5316 WHAT IS COVERED This warranty covers defects in material and workmanship under normal use, and applies only to the original purchaser providing that: The equipment has not been accidentally or intentionally damaged, altered or misused; The equipment is properly installed, adjusted, operated and maintained in accordance with national and local codes, and in accordance w
Warming Station Table of Contents Table of Contents .................................................................................................................................................... 3 Introduction.............................................................................................................................................................. 4 Safety Precautions ....................................................................................................................
Warming Station Introduction Congratulations! You have chosen a Warming Station that will give you many years of fine service from the original manufacturer, BKI. The BKI name and trademark on this unit assures you of the finest in design and engineering — that it has been built with care and dedication — using the best materials available.
Warming Station Keep this manual with the Equipment This manual is an important part of your equipment. Always keep it near for easy access. If you need to replace this manual, contact: BKI Technical Services Department P.O. Box 80400 Simpsonville, S.C. 29680-0400 Or call toll free: 1-800-927-6887 Outside the U.S., call 864-963-3471 Protect Children Keep children away from this equipment. Children may not understand that this equipment is dangerous for them and others.
Warming Station Safety Labels Models WS-13 On Back of Unit 6
Warming Station Model WS-15ST(C) 7
Warming Station Operation Models Once the unit is plugged in to the appropriate receptacle with the appropriate overcurrent protection (see rating tag), press the “I” portion of the power switch. Switch will illuminate, and the unit will begin to heat. IMPORTANT: Allow 20 minutes to preheat before loading product into Warming Station. Unit Shutdown 1. Press the “O” portion of the power switch. 2. Allow the equipment to cool to room temperature.
Warming Station Installation Serious injury, equipment damage or death could result if attempting to install this unit yourself. Ensure that an authorized BKI service agent installs the unit. Instructions For Shipping Damage You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for damage when they arrive.
Warming Station Maintenance Failure to comply with the maintenance below could result in a serious accident. Electrocution, equipment failure or property damage could result if an unlicensed electrician performs electrical repair. Ensure that a licensed electrician performs electrical repair. Scheduled Maintenance This unit should be cleaned at the end of each working day. Use the following procedure: Failure to remove power from this unit may cause severe electrical shock.
Warming Station Troubleshooting Problem Cause Possible Solution Unit will not turn on. Power cords not connected or circuit breaker supplying power to the unit has tripped. Make sure power cords are connected and circuit breaker is on. If problem persists contact a licensed electrician. Product is not holding it’s temperature Product temperature is too low when loaded. Make sure product is above 160 F when loaded.
P.O. Box 80400, Simpsonville, S.C. 29680-0400, USA http://www.bkideas.com Made and printed in the U.S.