Specifications

Page 17
724-746-5500 | blackbox.com
AVSW-HDMI2X2
Chapter 5: RS-232 Serial Commands
5. RS-232 Serial Commands
To switch inputs to outputs:
SBI02O0Y (where X is the output number [1-4] and Y is the input number [1-4]).
Unit will respond with:
SBUD0XOY (where X is the output number [1-4] and Y is the input number [1-4]).
Example: Send input 2 to output 3:
SBI02O03: Send
SBUD02O3: Recvd
5.1 Standby Mode
NOTES: Turning the unit‘s System Power Off over RS-232 will turn off the LED
display, leaving only the Power Switch LED on. The video and audio
outputs will also mute.
While the unit is turned off by RS-232, it will continue to accept and act
upon switching commands. For example, if the unit is in the off mode
(via RS-232) and you send a command to switch an input to an output,
that route will complete and the video and audio will now appear
on that channel only.
The front panel LED for that particular output will also show the input
selected (for that single output channel only). The remaining LEDs will
stay off and video and audio outputs muted.
The unit will still return status and change messages in response to
commands sent while in Power Off state.
A hard reset command (SBALLRST) will return the unit to normal
operation and also unlock the front panel.
5.2 Power Off Mode
SBSYSMOF: Put system into Standby (soft power off).
SBSYSMON: Bring the unit out of Standby (soft power on).
Unit will respond with:
SBALOFAX: Unit is in standby.
SBALONAK: Unit is no longer in standby.
Example: Put unit in standby (soft power).