Computer Hardware User Manual

71
5250 REMOTE EMULATOR CARD
1. Insert a paper tray of the proper size and press the printer’s RESET
button.
2. Power the printer OFF and back ON.
3. Release the print job at the host.
The System/38 uses a “Printer Support Facility” that sends the margins
and other document-form specifications to a printer only when these
are different from the previous document or when the printer has been
turned OFF. Either way, the LaserJet must be reset when a different paper
tray is installed.
The line-format screens in DisplayWrite/36 (Command 20) also permit
“Justify,” which aligns the right margin. “One-Half Justify” causes only
one-half as much alignment of the right margin. For best results in using
justification, change the zone width from “6” to “1.”
8.3.5 E NVELOPE P RINTING
To print envelopes, specify typestyle number 5, landscape orientation, with
the first line of the address on line 30 and a left margin of 55. A trial run
with a blank sheet of paper will often help identify an error in positioning
the address.
Manual Feed: Select the “Envelope Feed” option in the word-processing
program’s paper-feed selections and a paper size of 11" x 11". The printer
will flash “Manual Feed” on the front-panel display window. Manually feed
the envelope into the printer.
Envelope Tray: Select “Envelope Feed” and a paper size of 7.5" or 9.5"
(or 22 cm). The printer automatically finds the envelope tray (if this has
been installed) and prints the envelope.
Envelope Feeder: Select “Envelope Feed” and a paper width of 7.5"
o 9.5" (or 22 cm). The printer automatically finds the envelope feeder
(if this has been installed) and prints the envelope.
NOTE
The LaserJet may eject a blank page when you change print orientation.
8.3.6 D UPLEX P RINTING
Some LaserJet models can print both simplex (single sided) and duplex
(double sided); for that matter, they can print both long-edge (landscape)
and short-edge (portrait) duplex. However, changing the printer’s
simplex/ duplex mode through its front panel can be time consuming.
Instead, place printing commands on the first line of the document to
control simplex, landscape-duplex, and portrait-duplex printing. Enter one