Specifications

Model AC1032A-2A Users Manual
10
4.0 Operation
4.1 Switched Output
The switched output SELECT button is used to select between video &
audio input sources of PC 1 and PC 2. A solid-on LED is used to
indicate which input is selected.
Holding down the switched output SELECT button for 3 seconds will
blank the current selected input source (and mute the audio output).
The LED for the current selected input will start blinking to indicate
the blanking mode. Pressing the switched output SELECT button
again will un-blank the output and un-mute the audio on the switched
out rear connector.
MODEL AC1032A-2A FRONT PANEL
4.2 Modes of Operation
The unit can operate in either Auto or Manual mode by pressing the
mode button.
In Auto
mode, the AC1032A-2A will automatically select the input
with active video and audio. The presence of video is determined by
examining the V. Sync signal or optionally the +5 VDC signal from
DVI input connectors. The front panel switched output SELECT button
cannot be used to switch between ‘Input 1’ and ‘Input 2’ sources in this
mode. However, the switched output SELECT button can be used to
blank the output by holding it down for 3 seconds or to un-blank the
output by pressing it once.
In Manual mode, the output of the AC1032A-2A will depend on the
selection of the ‘Switched Output’ SELECT button.