Specifications

Model AC1032A-2 and AC1032-4
8
5. Plug the supplied power adapter to the unit
6. Turn on the monitor first. All red LEDs will flash back and forth
(telling you that the unit is searching for video on the inputs).
7. Turn on the PCs. The green LEDs turn on (telling you that the unit
sees a connection and valid signal on the inputs).
3. Operation
The LED’s indicate which input is selected and which inputs are
present. Simply press the switch next to the LEDs on any of the inputs
that have their green LEDs lit to select that input.
Note that you cannot select an input that is not preset or has no video
(the switch will not allow you). Furthermore, if you select an input that
has video and later that input is disconnected (or the Pc to which it was
plugged in is turned off), then the unit will select the next valid input.
Figure 4.
Setup Block Diagram