Network Hardware User Manual

5
CHAPTER 1: Specifications
1. Specifications
Compliance: CE; FCC Part 15 Subpart B Class A, IC Class/classe A
Standards: Video: VGA, SVGA, and XGA
Interfaces: VGA compatible video, 3.5-mm stereo audio, and a
proprietary composite of both of these
Video
Characteristics: Signal: Analog RGB, 0.7 volts peak-to-peak;
Impedance: 75 ohms;
Horizontal frequencies supported: 30 to 100 kHz;
Vertical frequencies (refresh rates) supported: 43 to
100 Hz;
Maximum resolution: 1280 x 1024 at 75 Hz;
Synchronization: TTL compatible, horizontal and
vertical positive/negative sync
Audio
Characteristics: Frequency response: 20 Hz to 16 kHz (at –3 dB);
Signal levels (V
in
V
out
maximum): 2 volts peak-to-peak
Maximum
Distance: 16.4 ft. (5 m) from a Hub or Remote to any attached
video or audio device;
360 ft. (110 m) of CAT5 cabling between the Hub and
the Remotes
User Control: Rear-mounted ON/OFF rocker switch;
On Remote only: Rear-mounted screwdial for focus
Indicator: Rear-mounted power LED
Connectors: On Hubs:
(1) HD15 male to the video-source device;
(1) HD15 female to the local monitor;
(2) 3.5-mm audio jacks: (1) to the audio-source device,
(1) to the local speakers or headphones;
(1) 4-pin DIN female power inlet;
RJ-45 female to Remotes:
AC150A(E)-2: (2);
AC150A(E)-4: (4);