Specifications

3
1. Disconnect the battery from the Hopper Harness at the white connector located on top of the battery (refer to Figure 1).
2. Loosen the nut, and remove the bracket holding the battery in place (refer to Figure 1).
3. Slide the battery forward, and then pick it up and out of the cabinet.
NOTE: The battery should be charged in a well-ventilated area. Dot not charge the battery in an enclosed space.
4. With the battery charger unplugged, connect its white connector to the white connector fastened to the top of the battery.
NOTE: If your charger has alligator clips, attach the black one to the negative (-) battery terminal, and the red one to
the positive (+) terminal. In order for current to flow, the clips must make contact with the battery’s metal terminals, so
loosen, but do not remove, the Faston connectors if necessary.
5. Once the charger is properly connected to the battery, plug it in to any 120 Volt AC outlet to begin charging. During
charging, the RED “Charging” LED on the battery charger will be ON solid. Continue charging until the GREEN
“Charged” LED turns ON solid, at which time charging is complete (refer to Figure 3). Charging times depend on the
extent that the battery has been discharged, and may take up to 14 hours or more for a 100% discharged battery.
CAUTION! NEVER store a discharged battery for any length of time, as this leads to a condition inside the battery
called sufation, which may cause a permanent loss of battery capacity. ALWAYS fully charge the battery immediately
after use, recharging as often as is practicable, in order to prolong its service life.
The supplied charger can remain connected to the battery and plugged in for any length of time without harm to the
battery.
6. When charging is complete, unplug the charger from the wall, and detach its connector from the battery.
7. Lift the battery back into the cabinet, and replace the metal bracket that holds it in place. Retighten the nut.
8. Reconnect the battery to the Hopper Harness at the white connector located on top of the battery.
FIGURE 3 – SUPPLIED BATTERY
CHARGER
Figure 4
Indicator
LED
Dump
Button
Bill
Meter
To
Remove
Coin
Bin