Specifications

14
6. Press the Program Button once; the LED should return to flashing yellow only.
7. Return the Rotary Switch to position 0.
8. Press and hold the Program Button until the LED returns to solid green, and then release it.
Bill Validator Maintenance
Both the Trilogy and APEX/XLC Bill Validators are designed to be maintenance free. To keep the validator
in its best possible working order, though, it will require an occasional cleaning. Detailed instructions for
cleaning the Bill Validator can be found in the Bill Validator’s Operation Manual, which is enclosed in the
manila envelope accompanying this manual. An Operation Manual may also be downloaded and printed
from the Pyramid Technologies, Inc. website at www.pyramidacceptors.com/support.html
. Please read
the validator’s Operation Manual carefully before attempting to clean the validator.
Coin Acceptor Maintenance
To ensure proper operation of the Condor Plus, the Coin Path area should be cleaned regularly – every
100,000 coins or 3 months, whichever occurs sooner. Dirt, dust, or any other grimy buildup can impair
the Coin Acceptor’s sensors, causing inaccurate discrimination and low acceptance of coins and/or tokens.
To access the Coin Path area, pull down on the top of the debris flap to swing it open by hand (refer to
Figure 6). Use ONLY a cloth dampened with water for cleaning.
Under NO circumstances should any solvent or foam-type cleaner be used!
Figure 6 – Condor Plus
AC Power Harness Installation
If an “AC Power Harness” was ordered with your AC401 changer, it will be located inside the manila
envelope shipped inside the cabinet, along with the keys and this manual. This harness, American
Changer Part Number AC400.16-H, allows the AC401 to be plugged into an AC electrical outlet, using the
supplied Battery Charger (Standard or Optional), for maintaining the battery at a full charge at all times.
NOTE: DO NOT remove the battery from the changer! The AC401 cannot be powered using the charger
alone. Please use the following instructions to properly install the harness in the changer.
1. Unlock and open the front door of your AC401 or AC401-COIN battery-powered changer.
2. Disconnect the battery from the Main Harness at the white two-position connector located on top of
the battery. The Main Harness runs up the left side of the cabinet to the battery at the top.
Coin Path
Debris F
lap
For more information visit www.Gumball.com | 800-260-0010 | [phone]