Specifications

11
FIBERPATH
4. Mount the FiberPath Receiver at the monitor or
device where the video will be received. Use the
mounting tabs on the housing or the enclosed
self-adhesive mounting pad.
5. Connect the remaining plug-in power supply to
the FiberPath Receiver’s input connector. If you
plan to use an external power source, make sure
it provides regulated 12-VDC ±10%. Current from
this source will not exceed 250 ma. When power
is applied, the red PWR LED indicator will glow.
NOTE
The negative (-) side of the power input is connected to the
enclosure.
6. Connect the video monitor or other video
receiving device to the BNC connector on the
FiberPath Receiver and the fiberoptic cable plug
to the optical connector on the Receiver.
7. For a pleasing picture, slowly adjust the LEVEL
control on the FiberPath Receiver. If you require
high accuracy, set this level to 1 volt pp with a
75-ohm load.
8. Your FiberPath video transmission system is now
installed.