Specifications

Page 15
724-746-5500 | blackbox.com
Chapter 3: Installation
3. Installation
Before installation, power off all devices that will be connected to this system.
Make sure that all devices you will connect are properly grounded.
Place cables away from fluorescent lights, air conditioners, and machines that are
likely to generate electrical noise.
NOTE: If no screen displays, follow these steps:
1. Make sure the device cables are correctly and firmly attached.
2. Set your Display device’s input source as DisplayPort.
3. Check the PC BIOS configuration for the video output settings.
4. Connect your computer to the Display DIRECTLY to check if the video signal
gets through.
3.1 Connection Pattern
Figure 3-1 shows a typical connection of the 4 x 1 DisplayPort Switch with Serial
and 3.5-mm Audio.
Serial
cable
1
2
3
3
5
4
4
6
Figure 3-1. AVSW-DP4X1A connection.