Specifications

Page 16
724-746-5500 | blackbox.com
Chapter 3: Installation
Table 3-1. Connection pattern, AVSW-DP4X1A.
Number Component Description
1 Power supply Apply the proper power to the unit.
2 Video output Connects to the display.
3 Video source (input) Connects to the video source.
4* Audio source (input) Connects to the audio source.
5* Audio output Connects to the speaker.
6* Serial connector Plug the serial cable in here.
*Available for AVSW-DP2X1A and AVSW-DP4X1A models only.
3.2 Installation Steps
1. Use a Video Cable (DisplayPort) to connect the Display to the video output port
on the back of the switch. For models with the standard audio feature, plug a
set of audio jacks from the speaker to the Switch’s speaker port.
2. Use a Video Cable (DisplayPort) to connect the source device to the video input
port on the switch. For the models that support audio (AVSW-DP2X1A and
AVSW-DP4X1A), use an audio cable to connect the speaker port from the input
side of the unit to the corresponding output port on the source device.
3. Plug the power supply into the switch and power on the switch.
4. Turn on the display (monitor, projector, or TV) and then power on the source
device(s).
NOTE: When each video source is powered on, make sure it has a display pointing
to it for EDID communication. If a source does not have a display pointing
to it, a video image might not display.