Specifications

Wizard Multimedia Extender LP
724-746-5500 | blackbox.com
Page 14
3.3.2 Connections at each remote module
3.3.2.1 To connect the link cable and video display
The link from the local module to each remote module is made using a twisted pair cable, specified to Category 5 or higher at a
maximum length of 492 feet (150 meters).
NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside power cables.
1 Attach the connector of the link cable to the socket on the remote module. There should be a click when the cable is fully
inserted and locked in place.
Figure 3-8. Connecting the remote (AVU4001A-RX) module
2 Attach the VGA connector of the module to the input socket of the video display.
No power input is required for the module.
If the video image requires adjustment, please refer to the section 3.4 Video sharpness adjustment.
Link cable from the
transmitter module
VGA input connector
on video monitor
Remote
AVU4001A-RX
module
IMPORTANT: The signals and power connections
sent through the link cables are NOT compatible
with standard networking equipment and could
cause damage if connected. Do not connect the
transmitter or receiver modules to any other
devices.