User's Manual

57
A/C-7P RO, A/C-7S RO
4.5 Restoring Factory Defaults
The factory-default configuration
can be restored either by sending
Host/PC Download Command
“Z98,0” or by taking the following
steps:
1. Power off the printer and the
A/C-7 RO.
2. Disconnect the host and PC
sharing cables from the
interface.
3. Set configuration switch SW1:1
(far left) to the “|” position, and
switch SW1:8 (far right of the
first bank of switches) to the “o”
position if it is not already there.
4. Power on the A/C-7 RO. The
factory defaults are restored.
The LED lights labeled “Host
Ready” and “Printer Ready” will
blink continuously, indicating
the A/C-7 (RO) is not in
operating mode.
5. Power off the A/C-7 RO and
return configuration switch
SW1:1 (on the first bank of
switches) to the “o” position.
Switch SW1:8 should be in the
“o” position as well.