Manualshelf

User's Manual

ManualsBrandsBlack Box ManualsNetwork HardwareBlack Box Black Box Network Hardware servsensor v4e lite with 20 or 60 vac or vdc dry contacts
41424344454647484950
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 41
EME149A-20
Chapter 3: Installation
Data Collection Type
This refers to the data collection from the sensor and how the data is then displayed on the graphs.
There are three options for collection of data: Average, Highest, and Lowest. The default setting is “Average.”
When the data collection type is set to “Average,” the output graphs for the daily, monthy, and yearly all have the same size on
the screen. For the daily graph, each data point on the graph is one data point collected from the sensor. But for the monthly and
yearly graph, to display more data into the same size as for the daily graph, some consolidation on the data is needed. One data
point on the monthly and yearly graph is the average of the sensor data in a range.
The maximum and minimum values showing on the monthly and yearly graphs are the value of this consolidated data and not
the raw data over that period of time.
When the Data Collection Type is set to the highest setting,then you will get the graphing output dsiplaying the sensor‘s highest
reading. This is the same for the lowest setting.
Figure 3-41. Advanced settings, display style.
Display Style
You can keep the sensors “Dislplay Style” in the Web interface as the Basic Style (slide bar) or you can change it to “Gauge Style.”