User's Manual

CHAPTER 4: TCP/IP Printing

4.5.3 C

ONFIGURING THE

RINT

ERVER FOR

RINTING

1. After starting the print-control utility, select the desired print server from the

displayed list. Print servers are identified through their serial number and

network address. Both of these are unique to the specific print server and can

be found on the bottom of the print server, as well as on the self-test print out.

2. Open the configuration dialog box by double clicking on the desired print

server or by highlighting the desired print server and then pressing the

Configure button displayed in the tool bar.

3. If the print server already has an IP address, proceed directly with step 4.

Otherwise, follow these instructions:

a. Select TCP/IP by clicking on the white box in front of that selection. The

column titled “Object Information” will display the available configuration

parameters.

b. Enter the print server IP address.

c. If necessary, enter the IP address for the default router and the subnet

mask. You may need to get this from the system administrator.

4. Select AS/400 AnyNet by clicking on the white box in front of that selection

in the left column of the print-control configuration screen.

5. The column titled “Object Information” will display the available

configuration parameters.

a. In the field titled “AS/400 IP Address,” enter the AS/400’s TCP/IP

address. Make sure to use the format specified in the field (for example,

XXX.XXX.XXX.XXX).

b. Enter the Host Network ID.

c. Enter the Host Control Point Name.

d. In the field titled “Interface Control Point Name,” enter the print server

name.

6. If you want to configure additional protocols, refer to the respective section.

If your configuration of the print server is complete, click on the Apply

Changes button on the bottom of the configuration window and reset the

print server. Then Exit the PrintControl utility.